Product ID:CHO-SHIELD 596
MSDS Date:04/06/1991
FSC:8010
NIIN:01-218-1645
Kit Part:Y
MSDS Number: BSSKZ

CHOMERICS, INC.

77 DRAGON COURT
WOBURN, MA 01888
US

Emergency Phone: 617-935-4850

Info Phone: 617-933-4318

Preparer: DAVID HAAS

Cage: 18565

PARKER HANNIFIN CORPORATION CHOMERICS DIVISION

WOBURN, MA 01888 US

Telephone: 617-935-4850

Cage: 18565

SILVER (SARA III)

CAS: 7440-22-4

RTECS: VW3500000

Fraction By Weight: 70-80%

OSHA PEL 0.01 MG/M3

ACGIH TLV: 0.1 MG/M3; 9293

EPA Report Quantity: 1 LB

DOT Report Quantity: 1 LB

BISPHENOL A EPOXY RESIN

CAS: 25036-25-3

Fraction By Weight: 10-15%

METHYL ISOBUTYL KETONE (SARA III)

CAS: 108-10-1

RTECS: SA9275000

Fraction By Weight: <5%

OSHA PEL 50 PPM/75 STEL

ACGIH TLV: 50 PPM/75 STEL; 9293

EPA Report Quantity: 5000 LBS

DOT Report Quantity: 5000 LBS

TALC (CONTAINING ASBESTOS)

CAS: 14807-96-6

RTECS: MW2700000

Fraction By Weight: <5%

OSHA PEL 0.2 FIBERS/CC

ACGIH TLV: 0.2 FIBERS/CC; 9293

TOLUENE (SARA III)

CAS: 108-88-3

RTECS: XS5250000

Fraction By Weight: 5-10%

OSHA PEL 100 PPM/150 STEL

ACGIH TLV: 50 PPM; 9293

EPA Report Quantity: 1000 LBS

DOT Report Quantity: 1000 LBS

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Health Hazards Acute and Chronic:OVEREXPOSURE TO TOLUENE HAS PRODUCED
SEVERE LIVER & KIDNEY INJURY, CENTRAL NERVOUS SYSTEM INJURY &
CARDIAC SENSITIZATION. CONTACT W/ AG & AG COMPOUNDS HAS BEEN
KNOWN TO CAUSE ARGYRIA, A BLUE DISCOLO RATION OF THE SKIN.
Effects of Overexposure:EYE IRRITATION. IRRITATION, DEFATTING, DRYING
OF SKIN. HIGH VAPOR CONCENTRATIONS MAY CAUSE RESPIRATORY
IRRITATION, HEADACHES, NAUSEA, DIZZINESS; ANESTHETIC EFFORTS OR
OTHER TEMP CENTRAL NERVOUS SYSTEM EFFECTS. SEVERITY IS DEPENDENT
ON VAPOR CONCENTRATION AND EXPOSURE SEVERITY.
Medical Cond Aggravated by Exposure:EXPOSURE MAY AGGRAVATE PREEXISTING
SKIN, EYE AND/OR RESPIRATORY DISORDERS.

First Aid:EYES-FLUSH W/H20 FOR AT LEAST 15 MIN, GET MD ATTENTION. SKIN-
REMOVE CONTAMINATED CLOTHING FLUSH AREA W/H20. THEN WASH W/SOAP &
H20. GET MD ATTEN IF CONDITION PERSISTS. DO NOT REUSE CONTAMINATED
CLOT HING UNTIL PROPERLY CLEANED. INHAL- REMOVE TO FRESH AIR, GET
MD ATTEN. INGEST- DO NOT INDUCE VOMITING. IF VICTIM IS CONSCIOUS &
ALERT DILUTE W/H20. GET MEDICAL ATTENTION.

Flash Point:40.0F,4.4C
Lower Limits:1.3%
Upper Limits:7.5%
Extinguishing Media:CARBON DIOXIDE, DRY CHEMICAL, FOAM, WATER FOG
Fire Fighting Procedures:VAPORS ARE HEAVIER THAN AIR, AND MAY TRAVEL A
CONSIDERABLE DISTANCE TO A SOURCE OF IGNITION AND FLASH BACK.
EVACUATE AREA & FIGHT FIRE FROM SAFE DISTANCE.
Unusual Fire/Explosion Hazard:DECOMPOSTION AND COMBUSTION PRODUCTS MAY
BE TOXIC. CLOSED CONTAINERS MAY VIOLENTLY RUPTURE UNDER FIRE
CONDITIONS.

Spill Release Procedures:ELIMINATE ALL SOURCES OF IGNITION. EVACUATE
ALL PERSONEL NOT DIRECTLY INVOLVED W/CLEAN UP. USE SPILL RESPONSE
EQUIP FOR POTENTIAL FLAMMABLE/EXPLOSIVE ENVIRONMENTS. APPLY
VERMICULITE TO SOAK UP RESID UE.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:STORE IN A COOL DRY LOCATION
W/ADEQUATE VENTILATION. KEEP CONTAINER TIGHTLY SEALED. DO NOT STORE
NEAR HEAT,SPARKS OR OPEN FLAME.
Other Precautions:GROUND STORAGE CONTAINERS TO ELIMINATE RISK FROM
EXPLOSION OF STATIC DISCHARGE. USE PPE WHEN HANDLING. BE SURE TO
USE EXPLOSION PROOF MECHANICAL VENTILATION

Respiratory Protection:USE AN APPROPRIATE, PROPERLY FITTED RESPIRATOR
IF EXPOSURES EXCEED PEL/TLV VALUES.
Ventilation:EXPLOSION-PROOF MECHANICAL EXHAUST VENTILATION TO KEEP
EXPOSURES BELOW PEL/TLV VALUES
Protective Gloves:CHEMICAL RESISTANT GLOVES.
Eye Protection:CHEMICAL SAFETY GLASSES/GOGGLES
Other Protective Equipment:CHEMICAL RESISTANT APRON. SAFETY SHOWER/EYE
WASH STATION.
Work Hygienic Practices:WASH THOROUGHLY AFTER HANDLING AND BEFORE
EATING, DRINKING OR SMOKING. LAUNDER CONTAMINATED CLOTHING BEFORE
REUSE.
Supplemental Safety and Health
THIS IS PART A OF A TWO PART KIT. REVIEW PART B FOR ADDITIONAL
INFORMATION. EXPOSURE TO THE FILLER MATERIAL LISTED IN SECTION 2
IS UNLIKELY TO OCCUR UNLESS THE PRODUCT IS APPLIED IN A MANNER
WHICH RE SULTS IN THE GENERATION OF MISTS OR FUMES, OR WHEN
MACHINING OF THE CURED PRODUCT RESULTS IN THE GENERATION OF DUST.

Boiling Pt:B.P. Text:N/D
Melt/Freeze Pt:M.P/F.P Text:N/D
Decomp Temp:Decomp Text:N/D
Vapor Pres:<10
Vapor Density:> AIR
Spec Gravity:>1.5
pH:N/D
Evaporation Rate & Reference:NONE SPECIFIED
Solubility in Water:INSOLUBLE
Appearance and Odor:GRAY LIQUID, SOLVENT ODOR
Percent Volatiles by Volume:20 %WT
Corrosion Rate:N/D

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZERS, ACIDS, BASES
Stability Condition to Avoid:AVOID STORAGE IN OPEN CONTAINERS, SOURCES
OF COMBUSTION,UNCONTROLED MIXING W/CURING AGENTS, OR INCOMPATIBLE
SUBSTANCES
Hazardous Decomposition Products:CO,CO2,ALDEHYDES,AG
COMPOUNDS,ACIDS,ORGANIC SUBSTANCES. TYPE AND QUANTITY DIRECTLY
PROPORTIONAL TO COMBUSTION CONDITIONS

Waste Disposal Methods:DISPOSAL MUST BE IN ACCORDANCE WITH ALL
APPLICABLE LOCAL, STATE AND FEDERAL REGULATIONS. COORDINATE WITH
SUPPORTING INSTALLATION AND/OR MACOM ENVIRONMENTAL OFFICE PRIOR TO
DISPOSAL

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.